If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
This one is handy, its a comparison of print strength with wider extrusion widths.
The results are basically:
Wider extrusion and fewer perimeters is stronger than more perimeters and a smaller width for a given shell thickness. Eg. 2 perimeters at 200% of nozzle width is better than 4 perimeters @ 100% of nozzle width
Print appearance and quality goes down with a higher extrusion width.
Comment