No announcement yet.

Laser cooling

  • Filter
  • Time
  • Show
Clear All
new posts

  • Laser cooling

  • #2
    Just a heads up, the new load of the chiller on the auxiliary outlets on the laser cutter has caused the inline fuse holder before the circuit breaker to overheat and burn out. I'm not bypassing it as I do not know how the downstream circuit breaker works in conjunction so until the entire connector assembly is replaced the laser cutter is down.

    Update: It was repaired this morning. The extra fuse made no sense as there was already a suitable circuit breaker and heavy guage wiring already installed and it was not rated for even 10A, hence why it burned out so quickly after we added the chiller. It's been approved that the fuse can be bypassed.
    Last edited by MIPS; 08-25-2019, 10:09 AM.