Announcement

Collapse
No announcement yet.

Slic3r Software

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Slic3r Software

    Hi guys, I'm installing the Slic3r software on my computer and it's asking for the firmware type used by our printer: The options are RepRap, Repetier, Teacup, MakerWare, Sailfish, Mach3, Machinekit,Smoothieware and No extrusion.

    Which one should I choose?

  • #2
    My instinct says RepRap.

    Anyone confirm?

    Darren

    Comment


    • #3
      Did you download slic3r from the Prusa website? I was never asked that question on installation.

      Comment


      • #4
        Joseph Prusa was one of the main RepRap developers - I can't imagine his printer using anything else.

        I'm pretty sure that the engine can be replaced, but I don't think anyone has done it.

        Darren

        Comment


        • #5
          The answer it seems is none of the above!

          I checked both my install of Slic3r and the Lounge Computer, they both are set up to use Marlin firmware for the G-Code.

          Comment

          Working...
          X